Quick Mount PV QMSC Classic Composition

New product

$19.50

Volume discount available in orders over 50 flashings, please contact us with your project requirements.

- +

 
Product information

The Quick Mount PV composition shingle flashing is made of aluminum and includes all stainless steel hardware. It works with all standard racking systems commonly used, installs seamlessly and provides a low profile mount.

With Quick Mount PV flashings there's no need for trimming shingles to force a fit. Drill one pilot hole into the rafter, backfill it with appropriate sealant, slide the Quick Mount flashing beneath the felt in the course above, drive the bolt home, and it's done.

The 12 x 12-inch Composition Mount flashing is designed to fit within a standard 5 to 5.5" course and the exposed course should be no greater than 5.75". If the exposure is greater than this, use the Shake Mount as an alternative. There's no shingle cutting and no shingle distortion caused by trying to force a fit. Just a permanent, watertight mount every time!

The Quick Mount PV Composition Roof Mount is the logical choice not only for solar PV installation, but also for rooftop solar hot water systems. In fact, whatever you need to fasten to a composition roof – HVAC equipment, antennas, satellite dishes – use Quick Mount PV to secure and protect every roof installation you put your name on.

Features of the Quick Mount PV QMSC:
- One bolt installation
- ICC-ES certified
- No shingle cutting
- 100% IBC, UBC compliant
- Meets or exceeds all NRCA standards and practices
- All aluminum flashing and mount
- Stainless steel hardware
- 50 year life
- Works with all leading racks

Available Finishes
- Aluminum mill
- Clear anodized
- Bronze anodized

Each mount kit includes:
- Cast aluminum mounting block (2-1/4" L x 1-1/4" W x 1-1/4" H) bonded with .05" thick, 12" x 12" aluminum flashing
- Hanger bolt, 5/16" x 6" (1-1/4" machine, 1-3/4" shank, 3" lag)
- Stainless steel and EPDM rubber sealing washer, 3/4" x 5/16"
- Two 5/16" hex nuts
- EPDM sealing washer with 60 Durometer hardness
- Stainless steel flat washer, 1" x 5/16"

Made in the USA and Canada. Compatible with the following solar racking systems:

AET
Conergy SunTop
DPW Power Rail
Haticon
IronRidge
JAC Products
ProSolar
Schletter
SnapNrack
Unirac
Unistrut
Zep Solar

 
Download datasheet

Quick Mount PV QMSC

Quick Mount PV instalation manual for the QMSC composition shigle roof flashing.

Download datasheet

30 Other products in the same category

Menu