Flexcharge Surge Arrester 36-48 VDC

SA3648DC

New product

$51.00

- +

 
Product information

The Flexcharge Surge Arresters will help protect your equipment against lightning strikes, switches, relays, and static electricity that can cause spikes and surges in your electrical system.

The Flexcharge Surge Arresters do not affect the sys the system until the voltage on the system reaches the breakdown voltage of the unit. Normally, high voltage spikes that are dissipated by the surge arrester will not damage the surge arrester and it will continue to protect your circuit.

The Flexcharge surge arresters will dissipate high voltage spikes to ground before the voltage in the system reaches extreme levels. Manufactured with UL approved components, each model is designed for specific voltage protection ranges on both DC and AC systems.  Install the unit near the device that you want to protect.  Some systems will require more than one unit for full protection.

Model: SA3648DC (Part# 20241)
Type: DC Surge Arrester
System Voltage: 36-48 VDC
Breakdown Voltage: 116-174 Volts

 
Sizing guide

Quick guide for selecting the right charge controller

Each time you charge deep cycle batteries with solar panels, it's necessary to use a charge controller in the circuit to protect the battery from over charging, and in some instances from over discharging. The only exception is when using solar panels smaller than 5W. Choosing the most suitable charge controller is simple and only requires two steps:

Step 1 - Voltage selection
Select a charge controller that is compatible with the system voltage. The standard configurations are 12, 24, and 48 volts. If you are wiring your batteries for 24 volts you need a charge controller that is rated at 24 volts.

Some controllers are voltage specific, meaning that the voltage cannot be changed or substituted. Other more sophisticated controllers include a voltage auto-detect feature, which allows it to be used with different voltage settings.

Step 2 - Current capacity

Select a charge controller that can handle the maximum output current of the solar panel (or solar array). The maximum possible current that a PV panel can generate is the “short circuit current,” indicated as Isc in the panel’s label or specs sheet.

It’s recommended to include a safety factor for isolated events as well. For example, a solar panel with a Isc of 7.89 amp could potentially produce an extra 25% on a sunny day with very clear snow pack. (additional light reflected off the snow). This results in a possible maximum of 9.86 amp (7.89 x 1.25 = 9.86 amp). In this case, a 10 amp charge controller would be recommended.

Below you will find a quick guide to choosing the proper charge controller for several popular solar panel sizes.

12V olar panels 5W - 45W
Phocos CM 04 Charge Controller 4A, 12V

12V solar panels up to 70W
Flexcharge PV7D Charge Controller 7A - 12V

12V solar panels up to 120W
Phocos CM 10 Charge Controller 10A, 12V
Phocos CMLup 10 Charge Controller 12/24V, 10A
Phocos ECO 10 Charge Controller 10A, 12V
Phocos ECO-N-10-T Charge Controller 10A, 12/24V

12V solar panels up to 160W
Flexcharge NC25A Charge Controller 25A – 12V
Phocos CMLup 20 Charge Controller 12/24V, 20A
Phocos ECO-N-20-T Charge Controller 10A, 12/24V

12V solar panels up to 160W
Flexcharge NC25A Charge Controller 25A – 24V
Phocos CMLup 10 Charge Controller 12/24V, 10A
Phocos ECO-N-10-T Charge Controller 10A, 12/24V

Menu